Industrial headphone stand assembly
All screws, allen key and special screwdriver is included in the box! See the video below for more detailed instructions.
- Attach the two center support pillars to the one of headphone stand's arms: Just place them where they should be and tighten the screw using the allen key
- Secure the second arm to the previously attached center support pillars using two more screws
- Place the center assembly onto the base and make sure it is facing the correct way (the bottom side of the center assembly has holes all the way through)
- Secure it to the base using two screws on each of the front facing screw holes, tighten the screws using the allen key; IMPORTANT: Beware that you might have to slightly flex the center assembly for the screw holes to align, this is completely normal
- Use two more screws in the remaining two screw holes on the bottom; IMPORTANT: use the provided pink screwdriver for these two as the space is to tight to properly use the allen key
- Attach the headphone rest on the top: Align the four screw holes on the top of the headphone stand and secure the top rest by tightening the four remaining screws
- DONE!